Chase Tactical 4SAS4 Level IV Rifle Armor Plate NIJ 04/05 – DEA Compliant

Subject: Addressing the BuffMan Review of the 4SAS4 Plate

We are aware of the recent Chase Tactical 4SAS4 plate review by BuffMan on YouTube. While we appreciate BuffMan’s efforts to test and review our products, it’s important to note that his testing conditions may differ from the controlled environments used for National Institute of Justice certification and in-house quality assurance.

This data reflects the rigorous testing our plates undergo to meet and exceed industry standards.

Thank you for bringing this review to our attention. Chase Tactical & HighCom Armor takes product performance and customer safety very seriously. While independent testing can vary significantly in setup and methodology from certified NIJ and in-house standards, Chase Tactical & HighCom Armor stands behind the quality of the 4SAS4 plate.

Please reach out with any specific questions—we’re here to ensure your confidence in the products we provide.

• The 4sas4 plate meets National Institute of Justice 0101.04 standards.
• The 4sas4 plates are DEA Compliant
• The 4sas4 are BERRY Compliant and Made in the USA
• NIJ 0101.04 standards require defeating a single round.
• Special threat plates are tested with one round, using multiple test samples.
• NIJ 0101.04 standards exclude drop testing
• 60,000+ plates deployed without complaints or recalls.
• 4sas4 Compliance Letter
• Chase Tactical 4SAS4 Spec Sheet
• Learn more: NIJ 04 vs. 06 standards

Chase Tactical 4SAS4 Level IV Rifle Armor Plates NIJ 04/05 & DEA Compliant

The Chase Tactical 4SAS4 Level IV Rifle Armor Plates are NIJ 04/05 Stand Alone Multi-Curve Plates. The 4SAS4 is also DEA Compliant, providing protection from Armor Piercing munitions, the 4SAS4 is an ideal choice for end users seeking an affordable high performing ballistic resistant armor plate.

4SAS7 Level IV Rifle Armor Plate Key Features:

• Protection: Level IV Stand Alone Armor Piercing
• NIJ Standard 0101.04 (2005IR)
• DEA: Hard Armor Protocol Compliant
• RST: Rifle Special Threats Validated
• Material: Ceramic strike face composite backing
• Exterior Cover: 1000D Cordura®, Textured Nylon, Polyester Veil, Polyurea
• Thinness: 0.75”
• Cut: The 10” x 12” shooters cut and multi-curve shooters cut plates are considered nominal and the actual measurement is 9.5” x 11.5”
• Warranty: 5 years on all ballistic material excluding exterior cover and 1 year on exterior cover material and workmanship.
• Disclaimer: Text shown on strike face is for marketing purposes only. The actual labels on Chase Tactical products are NIJ approved self-adhesive labels.
• BERRY Compliant
• Made in the USA